How to reprogram the Zero Gravity button if it's not working?

How to reprogram the Zero Gravity button if it's not working?

To reset/reprogram the Zero Gravity button, you will need to follow these instructions:

Step 1. Put your adjustable base in the flat position by pressing the FLAT button.

Step 2. Manually adjust the base by using the HEAD UP button to raise the head end approximately 15cm up off the base

Step 3 Next adjust the FOOT UP button to raise the foot end approximately 17cm off of the base.

Step 4. To save the preset to the Zero G memory function. Press and hold both the FLAT button and the Zero Gravity button until you hear a beep sound coming from the adjustable base. This indicates that you have successfully reprogrammed the Zero Gravity button.

You have now completed all the steps required to reprogram the Zero Gravity button.


    • Related Articles

    • How to reprogram the Anti-Snore button if it's not working?

      To reset/reprogram the Anti-Snore button, you will need to follow the instructions: Step 1. Put your adjustable base in the flat position by pressing the FLAT button. Step 2. Manually set your adjustable base to the Anti-Snore position by using the ...

    • What is the Zero G position?

      In short, Zero Gravity (zero G) gives the body a sense of weightlessness, decompressing the spine, relieving tension in the hips and pressure in the lower back. This is achieved by raising your head and knees slightly above your heart also creating a ...

    • iFit 2200F Adjustable Base Remote Connection Diagnosis Instruction

      Before doing anything, check if there is a Reset/Paring button on the power cord. The below image shows what it looks like. 1. For the 2200F without reset button on the power cord: Step 1 - Please check batteries are working and correctly inserted ...

    • iForm Motion Bed MA-Series Owner Manual (Installation and Operation Guide)

      OWNER MANUAL Installation & Operation iForm MA-1000/MA-2000(S)(M)/MA-3000M/MA-4000M READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT If unable to understand warnings, cautions, and/or instructions, contact the dealer or technical ...

    • How to pair the remote controls iForm (MA Series)?

      For ONE motor motion bed products (e.g. MA1 and 1000): 1. Press and hold the "Head Up" and "Head Down" buttons together; 2. Press the RESET button on the power cord (connected to the control box); 3. If you hear a beep sound, the synchronization has ...