Change remote ID (re-program handset) to disconnect synchronization between 2 bases

Please note, only doing this when failed to disconnect 2 bases synchronization after tried the below instruction
https://support.mlily.com.au/portal/en/kb/articles/iactive-remote-synchronization-desynchronization-instruction

Step 1: Remove one battery

Step 2: On one remote hold the Head Up and Foot Up buttons (below image) on the remote control

Step 3: Still pressed on the Head Up and Foot Up buttons, re-insert the removed battery

Step 4: Check the LED torchlight on the back of the remote control, the LED torchlight should start to illuminate

Step 5: After 5 seconds, the LED torchlight will lights off

Step 6: Release your fingers on the Head Up and Foot Up buttons, the LED torchlight will flash for 3 times, which indicates

the success of changing the remote ID/The remote is no longer paired to the base

Step 7: Re-pair the remote control with the base again

For paring the remote control with the adjustable base, please follow the below instruction

Paring Process Press and hold the Head Up and Foot Up buttons simultaneously and keep holding them. After 1 second, press the Reset/Pairing button on the power cord (fingers still pressing on the remote control buttons). If you are hearing beep sounds, it means the paring process is done successfully. You may release your finger from the remote control now.

• Related Articles

• iFit 2200F Adjustable Base Remote Connection Diagnosis Instruction

  Before doing anything, check if there is a Reset/Paring button on the power cord. The below image shows what it looks like. 1. For the 2200F without reset button on the power cord: Step 1 - Please check batteries are working and correctly inserted ...

• iActive (20M, 30M and 40M) Remote Synchronization & Desynchronization Instruction

  For iActive Adjustable Base Models with Massager (20M, 30M and 40M) follow the below instruction Step 1: Place Remote A on Adjustable Base A (Left), place Remote B on Adjustable Base B (Right) Step 2: Pick up the Remote A, change the position of the ...

• iFit Adjustable Beds remote control diagnosis instructions/troubleshooting

  Step 1 - Please check the LED on the power adapter is Green. If not, check the cable connections and power is connected. Step 2 - Check remote control to see if the buttons are illuminating. If yes, move to step 3. If no, try changing the battery and ...

• MLILY Adjustable Bed remote control diagnosis instructions/troubleshooting

  Step 1 - Please check the LED on the power adapter is Green. If not, check the cable connections and power is connected. Step 2 - Check remote control to see if the buttons are illuminating. If yes, move to step 3. If no, try changing the battery and ...

• How to pair the remote controls iForm (MA Series)?

  For ONE motor motion bed products (e.g. MA1 and 1000): 1. Press and hold the "Head Up" and "Head Down" buttons together; 2. Press the RESET button on the power cord (connected to the control box); 3. If you hear a beep sound, the synchronization has ...